Bdi 8828 BRADEN Bedienungsanleitung PDF herunterladen (Seite 4)

assembly instructions

bdiusa.com customerservice@bdiusa.com

braden

8828

STEP 2 - Adjust Door Hinges (if needed)

The doors on your cabinet should be evenly spaced and the doors should open and close freely without rubbing

against the door frame.

If the cabinet’s doors appear out of alignment, this condition can be corrected with minor adjustment to the

European hinges on each door.

Because these hinges are infinitely adjustable, adjusting one hinge element can sometimes cause the need for

adjustments to other elements. But with a few adjustments, you can modify the orientation of the cabinet doors

to make sure that they hang perfectly within your cabinet.

Use the Phillips Screwdriver (A) supplied to adjust Braden’s

door hinges:

• By adjusting Screw 1, the door will move LEFT or

RIGHT within the frame. Make minor adjustments

at both top and bottom hinges for best results.

• By adjusting Screw(s) 2, the door will move UP or

DOWN within the frame (the top and bottom hinges

must be adjusted the same degree). NOTE: Loosen

Screws 2 one complete turn, raise or lower door, then

hold in position while tightening Screws 2 (on both

hinges).

• By adjusting Screw 3 the entire door will move IN or

OUT, opening or closing the gap between the door

frame and cabinet. (This screw rarely needs adjustment.)

Fine tuning your new BDI Braden Home Theater Furniture

These steps are to be followed after you have unpacked and completed the simple assembly instructions for

your Braden AV stand. Due to jostling in freight or perhaps an uneven floor, the doors on your Braden stand

may not appear to be in perfect alignment. Making a few minor adjustments can rectify this situation. Be aware

that depending on your situation, patience and a bit of trial and error are required. The high-quality European

hinge hardware is infinitely adjustable, but changing one element can cause the need for further adjustments.

Through a little adjustment, you can modify the orientation of the cabinet doors to make sure that they are

sitting perfectly on your Braden unit.

STEP 1 - Level your Braden unit

Levelers are integrated into each leg assembly and are accessed at the bottom of each cabinet leg and are

hand-adjustable. If your floor is uneven, you may extend one or more levelers to attain a level, stable cabinet

placement. Turning the leveler clockwise will extend the leveler; turning it counter-clockwise will retract it.

CORRECT! Door is

sitting squarely and

evenly spaced on tops

and sides.

INCORRECT! Door is

out of alignment with

the rest of the unit.



1 2 3 4

i n s t r u c t i o n s 1
Door is 4

Kommentare zu diesen Handbüchern

Keine Kommentare

Bdi 8828 BRADEN Bedienungsanleitung Seite 4

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Möbel Bdi 8828 BRADEN